IV to po opioids: Equivalency

Pain

Inter-converting between oral and IV opioids is a very common situation encountered in clinical anesthesiology both in the context of treating acute perioperative pain, in the setting of chronic pain management or in combination.  In order to determine equivalency between opioid agents, equianalgesic dosing tables are utilized in order to convert dosing between route of administration in the same agent or to calculate equivalent dosing between agents. Potency between oral and parenteral preparations of the same agent are dependent on the oral bioavailability of the drug which is related to the degree that it undergoes first pass metabolism via the liver before entering the systemic circulation.  Determining equivalency between different opioid agents is however more complex and published equianalgesic dosing tables are not standardized and often provide varied information.

This equianalgesic data aims to provide relative potency information between different opioids, which can be defined according to Knotkova et al. as “the ratio of opioid doses necessary to obtain roughly equivalent [analgesic] effects”. This data was derived from various randomized, controlled, clinical trials conducted in the 1950s and 1960s with typically a partial cross over design where morphine (IV or PO) was used as the standard for comparison in order to derive relative potency information. This data collected over 50 years ago was published as equianalgesic opioid dosing tables that have remained mostly unchanged. This data however has limitations as the study population primary included patients with acute post operative pain and that were relatively opiate naive which calls into question whether this data can truly be applied to populations on chronic and large doses of opioids.

Below is a suggested approach to switching opioid agents adapted from Fine et. al, Gammaitoni et al. and Vadivelu, N. et al. with an emphasis on individualization for each patient.

  • Consider context and reason for switch (i.e. inadequate pain control/side effects vs. IV to PO to facilitate discharge)
  •  Full pain assessment to consider worsening of existing pain vs. new pathologic process, progression of disease, etc.
  •  Also consider patient related pharmacokinetic changes (i.e. change in hepatic function), patient expectations, noncompliance, or diversion.

3.  Determine the new opioid analgesic to convert to and using equianalgesic dosing data (taking into consideration the limitations) convert to new opioid dose.

  • Suggested reduction closer to 50% in patients on high dose of current opioid regimen, not of Caucasian ethnicity, elderly, renal impairment, or medically frail
  •  Suggested reduction closer to 25% if do not meet criteria above or switching route of administration using the same agent
  •  If pain at the time of switch is severely uncontrolled this downward dose adjustment may not be necessary

5.  Continue to reassess the patient in particular during the first 7-14 days, titrating dosing as needed. Manage break through pain with short acting opiates, rescue doses should typically be 5-15% of the total daily dose of the new agent.

null at https://www.openanesthesia.org/wp-content/uploads/2015/03/IV-to-po-opioids-%E2%80%93-Equivalency-table.png

70%

Answered correctly

2014

Year asked